RC-Monster Forums - View Single Post

Serum · 01.18.2008, 05:21 PM

Nothing negative about this auction, but I wouldn't use a 3.2mm shaft with the pinion sticking out THAT far.

Hard to tell; but is the shaft snapped of or not? If not, it will probably snap with the first couple of runs. a gearing ratio of 1:12 with that motor and a non sintered rotor will heat it up pretty badly too.

	(#9)
Serum RC-Monster Admin Offline Posts: 10,480 Join Date: Feb 2005	01.18.2008, 05:21 PM Nothing negative about this auction, but I wouldn't use a 3.2mm shaft with the pinion sticking out THAT far. Hard to tell; but is the shaft snapped of or not? If not, it will probably snap with the first couple of runs. a gearing ratio of 1:12 with that motor and a non sintered rotor will heat it up pretty badly too.