RC-Monster Forums - View Single Post - Another FLM Conversion Build-Help

04:15 PM

OK, finally got a good fit in the original ESC plate position. Used 5.5mm connectors and ran the wires under the plate. Everything is secure and its not as tight a fit as it looks. There is plenty of room between the caps and the motor (about 2 rch). Going to run the whole thing this evening and see how it goes. Oh, the padding under the ESC heatsink is some thermal CPU tape.

	(#3)
knotted Guest Posts: n/a	01.27.2008, 04:14 PM OK, finally got a good fit in the original ESC plate position. Used 5.5mm connectors and ran the wires under the plate. Everything is secure and its not as tight a fit as it looks. There is plenty of room between the caps and the motor (about 2 rch). Going to run the whole thing this evening and see how it goes. Oh, the padding under the ESC heatsink is some thermal CPU tape. Attached Thumbnails Last edited by knotted; 01.27.2008 at 04:15 PM.