RC-Monster Forums - View Single Post - e-revo having some issues

Sammus · 08:11 PM

Try locktighting the motor screws perhaps? Do em up tighter? I don't like the latter though I'm always afraid I'll strip the motor can :P

Also re: the slipper, how long had you been running nitro? If it was very worn to start with it may not have been able the hand the raw power of brushless from the get go - but some new pads could breathe a bit of life into it.

	(#2)
Sammus RC-Monster Titanium Offline Posts: 1,161 Join Date: Jan 2008 Location: All over Australia.	01.29.2008, 08:09 PM Try locktighting the motor screws perhaps? Do em up tighter? I don't like the latter though I'm always afraid I'll strip the motor can :P Also re: the slipper, how long had you been running nitro? If it was very worn to start with it may not have been able the hand the raw power of brushless from the get go - but some new pads could breathe a bit of life into it. Last edited by Sammus; 01.29.2008 at 08:11 PM.