hi everyone, i have an update on the build
I have mounted the front and rear ends to the chassis, the Gmaxx centre driveshafts line up really well. They were a bit of a tight fit into the UE drive cups but a little fuel tubing in each cup and the problem was solved.
I also had to rebuild my servo saver, as when i opened it to clean it the bearings kind of crumbled out onto the floor. But a set of new bearings and shes running like a champ.
I'm just waiting on some UE pillowballs so i can mount the knuckles and cvd's properly, they should be here in the next few days...
I'll post pics as soon as i get the pillowballs and finish up the suspension
thanks
jordan