RC-Monster Forums - View Single Post

BrianG · 02.06.2008, 06:03 PM

I would set all the default options in the PC software (and make sure it is in the right brushed/brushless mode), re-calibrate the transmitter, and see how it goes.

I assume all your ESC/motor connections are ok? A poor solder joint on even one phase wire can cause issues.

Does your old Mamba use the internal BEC or an outboard one?

Since the other Mamba works fine with the same setup, the problem is isolated to the new speedo.

	(#3)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	02.06.2008, 06:03 PM I would set all the default options in the PC software (and make sure it is in the right brushed/brushless mode), re-calibrate the transmitter, and see how it goes. I assume all your ESC/motor connections are ok? A poor solder joint on even one phase wire can cause issues. Does your old Mamba use the internal BEC or an outboard one? Since the other Mamba works fine with the same setup, the problem is isolated to the new speedo.