RC-Monster Forums - View Single Post - Is this a bit of overkill heatsinking? :P

Sammus · 02.26.2008, 01:38 AM

Lol nice detailed response cheers. The original post was a big tongue in cheek, I knew it was way overkill :) I was thinking of crosscutting the original sink or cutting down the fins of this one, maybe taking the outside layer of fins off so it actually fits properly.

Also I dont have a mill, so I guess sandpaper will have to do the job. If i can be bothered, I'll finish with 1200 wet/dry then polish for optimum heat conductance :D

	(#6)
Sammus RC-Monster Titanium Offline Posts: 1,161 Join Date: Jan 2008 Location: All over Australia.	02.26.2008, 01:38 AM Lol nice detailed response cheers. The original post was a big tongue in cheek, I knew it was way overkill :) I was thinking of crosscutting the original sink or cutting down the fins of this one, maybe taking the outside layer of fins off so it actually fits properly. Also I dont have a mill, so I guess sandpaper will have to do the job. If i can be bothered, I'll finish with 1200 wet/dry then polish for optimum heat conductance :D