RC-Monster Forums - View Single Post - Revo Slipper on E-Maxx Tranny Mod :)

MetalMan · 03.06.2008, 04:31 PM

MGT spur gears, with 3 of the slipper peg holes drilled out to 5mm and with washers under the screw heads to keep the gear from sliding off, fit on the Revo slipper clutch perfectly. I've used them on several Revo slipper clutch plates, and it works perfectly every time. The gears come in sizes up to 52t, and they are mod1.

	(#49)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	03.06.2008, 04:31 PM MGT spur gears, with 3 of the slipper peg holes drilled out to 5mm and with washers under the screw heads to keep the gear from sliding off, fit on the Revo slipper clutch perfectly. I've used them on several Revo slipper clutch plates, and it works perfectly every time. The gears come in sizes up to 52t, and they are mod1. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz