RC-Monster Forums - View Single Post - Revo Slipper on E-Maxx Tranny Mod :)

pun15her · 03.07.2008, 11:05 AM

Here is mine so far.
I am using the revo input shaft with 7mm sawn off the end,along with the revo output shaft. This is with the 68t e maxx spur attached.(This was the only spur my local shop could get for now!)

Cheers P

	(#11)
pun15her RC-Monster Stock Offline Posts: 9 Join Date: Feb 2008	03.07.2008, 11:05 AM Here is mine so far. I am using the revo input shaft with 7mm sawn off the end,along with the revo output shaft. This is with the 68t e maxx spur attached.(This was the only spur my local shop could get for now!) Cheers P I only punish the guilty.