RC-Monster Forums - View Single Post - Project E-Revo

mahazael · 03.13.2008, 08:31 PM

awesome freaking conversion man. I am actually going to be starting mine tomorrow. You have inspired me and showed some good resources on how to do a good conversion.

I am actually interested in using the novak HV 4.5 setup with the 3amp HV bec unit which allows the HV up to 7s lipos/22 nimh. While I think 7s LiPo would be just stupid fast (and cook the internals) it is nice that it would allow for a 5s without worry.

http://www.teamnovak.com/products/BEC/index.html

What are thoughts on that? I would probably lock the 2nd gear add the 5mm sintered rotor. What types of gearing would be used etc?

Do you see a benefit in this system..

I had actually considered going the route of the NEU w/ a quark monster pro but I am not much of a MM fan (seen too many fried.. and cogging.. ugh - although I hear the new software fixed that)

Also, w/ the release of the new e-maxx with revo slipper.. those spur gears will now fit on to the stock revo.. however there is problem of the size of them. They may not fit without a bit more modding of the rcm revo electric motor mount (spacing and meshing). Anyone tried?

Just some thoughts..

	(#10)
mahazael RC-Monster Stock Offline Posts: 29 Join Date: Jan 2007 Location: northern cali	03.13.2008, 08:31 PM awesome freaking conversion man. I am actually going to be starting mine tomorrow. You have inspired me and showed some good resources on how to do a good conversion. I am actually interested in using the novak HV 4.5 setup with the 3amp HV bec unit which allows the HV up to 7s lipos/22 nimh. While I think 7s LiPo would be just stupid fast (and cook the internals) it is nice that it would allow for a 5s without worry. http://www.teamnovak.com/products/BEC/index.html What are thoughts on that? I would probably lock the 2nd gear add the 5mm sintered rotor. What types of gearing would be used etc? Do you see a benefit in this system.. I had actually considered going the route of the NEU w/ a quark monster pro but I am not much of a MM fan (seen too many fried.. and cogging.. ugh - although I hear the new software fixed that) Also, w/ the release of the new e-maxx with revo slipper.. those spur gears will now fit on to the stock revo.. however there is problem of the size of them. They may not fit without a bit more modding of the rcm revo electric motor mount (spacing and meshing). Anyone tried? Just some thoughts..