RC-Monster Forums - View Single Post - Revo motor mount stripped thread... again

jnev · 03.17.2008, 10:14 AM

I can not imagine over tightening them. I am just using a XTM hex driver and turning 'till it won't turn. In plastic, I won't go as tight, but metal in metal, I thought it should be really tight, especially in such an important part as the motor mount.

I'll take it apart this afternoon. I really hope that it is not the mount and just the screws... lets hope for the best.

	(#3)
jnev RC-Monster Brushless Offline Posts: 2,864 Join Date: Jan 2007 Location: SoCal	03.17.2008, 10:14 AM I can not imagine over tightening them. I am just using a XTM hex driver and turning 'till it won't turn. In plastic, I won't go as tight, but metal in metal, I thought it should be really tight, especially in such an important part as the motor mount. I'll take it apart this afternoon. I really hope that it is not the mount and just the screws... lets hope for the best.