Quote:
Originally Posted by Arct1k
Cost (theortically cheaper), Support (US based / no quibble warrantee), Software (Link will be like MM).
|
Im in Sweden so US based does not matter too much to me. Isn't PC software any good for MGM? Looks ok here I think?
http://www.rc-monster.com/forum/show...&highlight=rc8
Quote:
Originally Posted by Arct1k
4S should be fine with a MM with BEC and an extra cap though... Just send it back for repair.
|
Well im not sure if I voided the warranty....a motor wire was damage and I solded on a 5.5m plug on the part of the cabel that was left in on the controller. I didn´t solder "on" the board but pretty close. Im not sure if this has something to do with it not working or not. I ran 2 8000mah lipos through it after i soldered it and on the 3 lipo it thermeled and it didnt start again. Keeps flashing all lights when I turn it on.