RC-Monster Forums - View Single Post

DrKnow65 · 11:05 PM

Got off way lucky, a moment of not looking and bang, it's done...

MetalMan, what were you doing on the scroll saw for 6 hours??? (building something cool out of aluminum I hope...)

Suicideniel, I've seen some of the stuff about AC brushless motors, but it does look far off for it to go RC...

Dang Luatch, you've looked into the low KV motors!!! What do people use to spin those motors now? Are there already esc's that will do over 40v?
P.S. did you ever try a TCS cooling system? I was looking at some old posts and saw you had interest at one point. I'm thinking about doing a stage 2 mod to my MM with a liquid cooler sandwitched between the boards (pressed for room in a 1/10 buggy I'm running, very little air flow without perferating the body)

	(#9)
DrKnow65 RC-Monster Aluminum Offline Posts: 998 Join Date: Oct 2007 Location: Colorado	03.23.2008, 11:02 PM Got off way lucky, a moment of not looking and bang, it's done... MetalMan, what were you doing on the scroll saw for 6 hours??? (building something cool out of aluminum I hope...) Suicideniel, I've seen some of the stuff about AC brushless motors, but it does look far off for it to go RC... Dang Luatch, you've looked into the low KV motors!!! What do people use to spin those motors now? Are there already esc's that will do over 40v? P.S. did you ever try a TCS cooling system? I was looking at some old posts and saw you had interest at one point. I'm thinking about doing a stage 2 mod to my MM with a liquid cooler sandwitched between the boards (pressed for room in a 1/10 buggy I'm running, very little air flow without perferating the body) If I could only draw what I see in my head, then afford to build it, and finaly get to play with it... Last edited by DrKnow65; 03.23.2008 at 11:05 PM.