RC-Monster Forums - View Single Post - Programming a Monster Pro and S&T e-mail address

BrianG · 05:24 PM

Not sure about the email address, but have you tried to center your throttle trim and set your forward and reverse EPA to 100%? If you can, set the EPA to as high as it can go. It sounds like the ESC is not seeing the required ~2ms pulses for max throttle to enter programming mode.

Something else to check out: The button on one of my Quarks is not quite in the exact proper position for effective pressing. I had to use a hex wrench tip to get it to press. Or, you could pop off the top plastic plate (don't slide it off!) to get to the button. I assume you've read the manual...

	(#2)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	03.27.2008, 05:18 PM Not sure about the email address, but have you tried to center your throttle trim and set your forward and reverse EPA to 100%? If you can, set the EPA to as high as it can go. It sounds like the ESC is not seeing the required ~2ms pulses for max throttle to enter programming mode. Something else to check out: The button on one of my Quarks is not quite in the exact proper position for effective pressing. I had to use a hex wrench tip to get it to press. Or, you could pop off the top plastic plate (don't slide it off!) to get to the button. I assume you've read the manual... Last edited by BrianG; 03.27.2008 at 05:24 PM.