RC-Monster Forums - View Single Post

Maxxman · 03.28.2008, 08:04 AM

Honestly, it isn't that hard. You just have to go slowly up and down with the disc at an angle to the shaft and make sure that you have a pinion available to check the shafts size. Just don't do too much at a time and if its close to sliding on use a bit of sand paper or something similar to get the last little bit off.

	(#79)
Maxxman RC-Monster Carbon Fiber Offline Posts: 91 Join Date: May 2007	03.28.2008, 08:04 AM Honestly, it isn't that hard. You just have to go slowly up and down with the disc at an angle to the shaft and make sure that you have a pinion available to check the shafts size. Just don't do too much at a time and if its close to sliding on use a bit of sand paper or something similar to get the last little bit off.