[kingiggy262]

Hey I will see if I can give some advice here. When you first program the controller to the receiver it seems like you almost got all the steps necessary:

The controller switch must be off. Then plugg in the batteries into the controller. Hold full throttle and turn the switch on. Keep holding until you here 3 beeps, grab full brake until you hear 1 beep, and then move to neutral until you hear 2 beeps. Then shut everything down, hook up all necessary wires and turn it back on and go to programming on your laptop.

As for your programming options everything seems ok except that you should try settings the range of neutral zone to either 9% or 12% to begin with. Also you may want to try once with the type of model set to car |=> but thats only if you don't want reverse. And I like to set the Freewheel to YES but I guess that is just personal preference.

If that still doesn't work then maybe try switching two of the motor to esc wires and see if it initializes. Otherwise it sounds like it could just be a faulty controller from the manufacturer.

Hope it works out for you!