Quote:
Originally Posted by Gallagher
Thank you for the reply.
Pleas send me your mod. pictures.
Is it easy to drill the revo shaft and with what size of drill bit?
|
Here is what mod looks like once it complete.
You need to use a 5/64 bit for your new Revo output shaft # 5366 / slipper application and will also need to remove approximately 7mm of the end. (I'm fabricating an output shaft for a budy of mine and will post before and after pics in a few days)
If your using a MOD1 spur you'll need a 27/64 for the center (for your 5x10mm bearing) you will also need to drill (3) holes bit size 13/64 for your clutch plate.
Here is great link explaining the process in detail..
http://www.rc-monster.com/forum/show...ht=MAXX+TRANNY
Here are some pictures of trans installed on chassis.
Hope that helps??
Let me know if I can of further assistance..
Have a great one..
Shaun.
PS.
You will a need drill press to drill all of the above holes.. (Sorry)..