RC-Monster Forums - View Single Post

rschoi_75 · 03:12 PM

Thanks gtx.

I was able to take it out yesterday, and it runs like a beast! I was worried that heat may become a problem, but after running it yesterday, my worries are gone. The MM did get a bit hot, but stayed under 140F. It should be fine until I get my MMM from mike. (I missed the pre-order sale, so it may be late may by the time I get it). The motor was under 110F and the lipos weren't even warm, so I didn't even bother getting temps for those. Ambient temps were 80-85F (its getting hot!), so I'm pretty happy with the results.

As always, thanks to all the guys here for the advice and ideas.

	(#19)
rschoi_75 Certified Spaceball Offline Posts: 675 Join Date: Jun 2007 Location: CA	04.28.2008, 02:42 PM Thanks gtx. I was able to take it out yesterday, and it runs like a beast! I was worried that heat may become a problem, but after running it yesterday, my worries are gone. The MM did get a bit hot, but stayed under 140F. It should be fine until I get my MMM from mike. (I missed the pre-order sale, so it may be late may by the time I get it). The motor was under 110F and the lipos weren't even warm, so I didn't even bother getting temps for those. Ambient temps were 80-85F (its getting hot!), so I'm pretty happy with the results. As always, thanks to all the guys here for the advice and ideas. There's two sides to every schwartz, he got the up side and I got the down side. rcm xt8 rcm xb8 rcm crt.5 Last edited by rschoi_75; 04.28.2008 at 03:12 PM.