RC-Monster Forums - View Single Post - MGM 16018 auto-tuning problem

05.05.2008, 08:22 AM

David,

The only way I was able to do autotuning with my 16018 was to initiate it by programming with the controller. Using the PC software to initiate autotune was always unsuccessful. I would experience the beeping as you mentioned, and could not get the ESC to respond until after a power cycle.

Try going through the programming with the TX, and set it to autotune. This should work :).

J.

	(#12)
83gt Guest Posts: n/a	05.05.2008, 08:22 AM David, The only way I was able to do autotuning with my 16018 was to initiate it by programming with the controller. Using the PC software to initiate autotune was always unsuccessful. I would experience the beeping as you mentioned, and could not get the ESC to respond until after a power cycle. Try going through the programming with the TX, and set it to autotune. This should work :). J.