RC-Monster Forums - View Single Post

BrianG · 05.09.2008, 03:08 PM

Unfortunately, unless the PSU tells you which rail to load, it's a bit of trial and error.

Can't remember where I got my shims - I think I just collected them over time and happened to have the ones I needed. Just use your bearing size to determine the size of the shims (and don't forget; the shim width cannot span both edges of the bearing or it'll rub).

	(#10)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	05.09.2008, 03:08 PM Unfortunately, unless the PSU tells you which rail to load, it's a bit of trial and error. Can't remember where I got my shims - I think I just collected them over time and happened to have the ones I needed. Just use your bearing size to determine the size of the shims (and don't forget; the shim width cannot span both edges of the bearing or it'll rub).