RC-Monster Forums - View Single Post

Gustav · 07:51 AM

Does anyone know of a good way to put curved bends into 3mm aluminium.It's for the upper plates i'm making to adapt LST bulks to a thuder tiger EB4 S3 box section chassis,i need to put S-bends in them.Only thing i can think of is bending it over a suitable radius steel pipe,maybe with some heat.Any ideas?

	(#23)
Gustav RC-Monster Aluminum Offline Posts: 916 Join Date: Jul 2005 Location: UK	09.22.2005, 07:49 AM Does anyone know of a good way to put curved bends into 3mm aluminium.It's for the upper plates i'm making to adapt LST bulks to a thuder tiger EB4 S3 box section chassis,i need to put S-bends in them.Only thing i can think of is bending it over a suitable radius steel pipe,maybe with some heat.Any ideas? Last edited by Gustav; 09.22.2005 at 07:51 AM.