RC-Monster Forums - View Single Post

rootar · 05.22.2008, 09:37 AM

yes it uses hub exteneders and buggy arms, i did disassemble the extenders the other day to see how they were built because they have zero slack in anydirection which is odd for a hub extension cause they usually have a little tiny bit of play no matter what, and i learned im not tkaing these off unless i have too they are a PITA and fit extremely tight, i guess the wheel bearings will wear out a little faster due to the extra leverage on them but i doubt ill have any problems out of the extenders.

besides i could always yank the wheel extenders off, throw some buggy tires on there and the wing and mounts from a strom and id have a 1/8 scale buggy with a 13.75 inch wheelbase lol thatd be one good handling buggy.

	(#8)
rootar RC-Monster Titanium Offline Posts: 1,803 Join Date: Aug 2005 Location: arkansas	05.22.2008, 09:37 AM yes it uses hub exteneders and buggy arms, i did disassemble the extenders the other day to see how they were built because they have zero slack in anydirection which is odd for a hub extension cause they usually have a little tiny bit of play no matter what, and i learned im not tkaing these off unless i have too they are a PITA and fit extremely tight, i guess the wheel bearings will wear out a little faster due to the extra leverage on them but i doubt ill have any problems out of the extenders. besides i could always yank the wheel extenders off, throw some buggy tires on there and the wing and mounts from a strom and id have a 1/8 scale buggy with a 13.75 inch wheelbase lol thatd be one good handling buggy.