RC-Monster Forums - View Single Post - Hitec HS-645MG enough for single servo Revo?

Arct1k · 05:21 PM

High Torque Standard Servos
4.8V Stall Torque oz-in
6.0V Stall Torque oz-in
4.8V Operating Speed sec/60° at no load
6.0V Operating Speed sec/60° at no load

HS-645MG
107
133
.24 sec.
.20 sec.

HS-5645MG - DIGITAL
143
168
.23 sec.
.18 sec.

HS-5955TG - DIGITAL
250
333
.19 sec.
.15 sec.

I used a 5645 for a while which was OK, i now have a 5955 which is seems light years better. I think a 645 may struggle esp on 5v... Be careful about turning when stationary if you can...

	(#4)
Arct1k RC-Monster Mod Offline Posts: 6,597 Join Date: Apr 2007 Location: NJ	05.30.2008, 04:52 PM High Torque Standard Servos 4.8V Stall Torque oz-in 6.0V Stall Torque oz-in 4.8V Operating Speed sec/60° at no load 6.0V Operating Speed sec/60° at no load HS-645MG 107 133 .24 sec. .20 sec. HS-5645MG - DIGITAL 143 168 .23 sec. .18 sec. HS-5955TG - DIGITAL 250 333 .19 sec. .15 sec. I used a 5645 for a while which was OK, i now have a 5955 which is seems light years better. I think a 645 may struggle esp on 5v... Be careful about turning when stationary if you can... Last edited by Arct1k; 05.30.2008 at 05:21 PM.