RC-Monster Forums - View Single Post

Sammus · **Hyperion Charger -** 06.03.2008, 05:17 AM

Hi, I have a hyperion DUO and have recently been paying a little closer attention to it charging my packs.

I've noticed that i kind of 'pulse' charges.. it goes full current for about a minute, then the current cuts back to zero for a few seconds, then its back on.

Also I'm a little concerned watching the balancer view, because it always takes the packs higher than they should go :( eg it will take lipo packs to over 4.3V before the CV starts, and A123 packs get to a hair over 3.7V. I thought it should be 4.2V and 3.6V resp?

Anyone else noticed any of this kind of behaviour? I run the latest firmware.

	(#1)
Sammus RC-Monster Titanium Offline Posts: 1,161 Join Date: Jan 2008 Location: All over Australia.	Hyperion Charger - 06.03.2008, 05:17 AM Hi, I have a hyperion DUO and have recently been paying a little closer attention to it charging my packs. I've noticed that i kind of 'pulse' charges.. it goes full current for about a minute, then the current cuts back to zero for a few seconds, then its back on. Also I'm a little concerned watching the balancer view, because it always takes the packs higher than they should go :( eg it will take lipo packs to over 4.3V before the CV starts, and A123 packs get to a hair over 3.7V. I thought it should be 4.2V and 3.6V resp? Anyone else noticed any of this kind of behaviour? I run the latest firmware.