....So I finally get the final piece to complete my brushless 8ight conversion (battery tray) and I get everything hooked and it's powered on with the fan buzzing as usual....when suddenly as i was adjusting the toe on my front wheels the MMM fan stops and the whole thing shuts down
...This may seem like the same old story with all the MMM dying however....THIS MMM already had the warranty work done on it with the new component already soldered onto the circuit board.....hmmmm....it's a good thing i still have my old MM otherwise my 8ight project would have been put on hold
...anyways my setup was.....8ight...neu 1515 1/y/f....and the battery was a 4s 5000mah thunderpower lipo (25c) and i didn't even get to rev the throttle since i was just messing around with setting the steering up right
......I have another MMM thats in my 8ight-t that is working flawlessly on 6s but I'm running the CC BEC on it.....what do you guys think of this?