RC-Monster Forums - View Single Post

BrianG · 06.06.2008, 09:54 PM

If you push on the tabs only as much as you need, you shouldn't break them. Just loosen one, and gently apply a little opening pressure on the case to keep that tab from relocking while you work on the other ones.

If you get a fan with different connector than the one on the MMM, then yes, you'll need some soldering.

	(#2)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	06.06.2008, 09:54 PM If you push on the tabs only as much as you need, you shouldn't break them. Just loosen one, and gently apply a little opening pressure on the case to keep that tab from relocking while you work on the other ones. If you get a fan with different connector than the one on the MMM, then yes, you'll need some soldering.