[jhautz]

Good question on the male bullets... If that one is mine artur, I run females on the speedo and males on the motor. No biggie, I can change them myself, but in case you wanted to know.

linc.. I always use a micro deans on the BEC. Makes changing parts easier for testing different setups.

Looking forwardto getting my hands on that bad boy and putting it through its paces. It was a great speedo beofre the mods, I'm hoping this lets me run with no thermal concerns any more. I had alot of suces with the little esc in its stock form, but always felt like I didnt want to push it to hard because of its small size and lack of heatsink.


Wondering if leaving the solder posts uncovered would also allow them to disipate some heat like they did in ots stock form.