RC-Monster Forums - View Single Post

traxxasrevony · 07.09.2008, 07:22 PM

you could make one super easy.

get a piece of aluminum flat stock and screw it down to the factory motor mount and have it hang over the side with the spur a little bit then get a suitable piece of aluminum angle and bolt it to the plate on the truck then put your motor screws in your motor of choice and measure the spaceing of the screw center to center. then drill your motor holes and a hole right in the center of them for your motor shaft. drill your hole 1-2 sizes bigger than the shaft.

the setback of the angle on the plate will depend on if you use pinion on the motor or a clutch adaptor.

	(#3)
traxxasrevony RC-Monster Carbon Fiber Offline Posts: 148 Join Date: Jun 2008	07.09.2008, 07:22 PM you could make one super easy. get a piece of aluminum flat stock and screw it down to the factory motor mount and have it hang over the side with the spur a little bit then get a suitable piece of aluminum angle and bolt it to the plate on the truck then put your motor screws in your motor of choice and measure the spaceing of the screw center to center. then drill your motor holes and a hole right in the center of them for your motor shaft. drill your hole 1-2 sizes bigger than the shaft. the setback of the angle on the plate will depend on if you use pinion on the motor or a clutch adaptor.