RC-Monster Forums - View Single Post - Dual Revo 3.3 BL conversion build-up

Topspeedtimmy · 12:48 PM

Got another Velineon motor and another combo so the motors are both new, just one old ESC, checked both ESCs and they are the same version. Soldered an H connector out of Deans to connect 2 batteries and 2 ESCs.

Also put on RPM tru-track.

When I disconnected the motor wire on my old ESC the bullet pulled out of the case

tried soldering it back on. Got a short 10 min. run and things heated up a lot.
synced the motors and it ran much smoother and cooler for another 20 minutes. The run ended when I was cruising up a grass hill punched the throttle to 2/3 and it rotated backwards onto a driveway and skidded on the deans plugs and grinded the motor mount.

The bullet came out again, don't know what to do.

	(#10)
Topspeedtimmy trick mad power (tmp) Offline Posts: 102 Join Date: Nov 2007 Location: NE	07.10.2008, 12:43 PM Got another Velineon motor and another combo so the motors are both new, just one old ESC, checked both ESCs and they are the same version. Soldered an H connector out of Deans to connect 2 batteries and 2 ESCs. Also put on RPM tru-track. When I disconnected the motor wire on my old ESC the bullet pulled out of the case tried soldering it back on. Got a short 10 min. run and things heated up a lot. synced the motors and it ran much smoother and cooler for another 20 minutes. The run ended when I was cruising up a grass hill punched the throttle to 2/3 and it rotated backwards onto a driveway and skidded on the deans plugs and grinded the motor mount. The bullet came out again, don't know what to do. Attached Thumbnails The timmy - Revo 3.3 MM 9XL 4s , Rustler MM 4600 3s The ferty - Dual velineon Revo 3s, Rustler velineon 3s Last edited by Topspeedtimmy; 07.10.2008 at 12:48 PM.