Quote:
Originally Posted by MetalMan
Surprisingly I had an issue with my Neu 1512 2.5D/F and MMM. At one point on the track it was cogging VERY badly at startup. Normally I would just go over to it and check out what was wrong, but the cogging was intermittent. When I finally took temps, my Neu was at 220 deg. F and the MMM was at 190! Normally that same setup would've been 160 for the Neu and ~140 on the MMM. I let everything cool down, and all was fine... I have no idea.
|
when I ran the MMM for the first time I had the timing on the default setting which was set at 10 and the motor was between very warm and hot, I lowered it down to 0 and it gets a little warm after a 30 min bash session