RC-Monster Forums - View Single Post

sikeston34m · 07.11.2008, 06:22 PM

I just did a test run in my E Revo with a 36-50-2600 Ammo motor.

Power is there! You can't hit wide open throttle without doing a standing backflip. Wheelies at speed, rooster tails of gravel, the whole nine yards.

The only thing is, on 4S 5000mah 20C Lipo and geared 20/68, it does tend to get hot after about 10 minutes.

I'm not running a heat sink yet, but will be running a heat sink and a motor fan to see if that helps. I may still be geared a little too high. Top Speed is up there.

I can tell it's pulling some amps since I'm detecting some heat from the 125 amp Quark Monster Pro.

Quite the Peppy Motor if you ask me. I just have to get the gearing right and the temps in check.

	(#12)
sikeston34m RC-Monster Brushless Offline Posts: 2,085 Join Date: Sep 2007	07.11.2008, 06:22 PM I just did a test run in my E Revo with a 36-50-2600 Ammo motor. Power is there! You can't hit wide open throttle without doing a standing backflip. Wheelies at speed, rooster tails of gravel, the whole nine yards. The only thing is, on 4S 5000mah 20C Lipo and geared 20/68, it does tend to get hot after about 10 minutes. I'm not running a heat sink yet, but will be running a heat sink and a motor fan to see if that helps. I may still be geared a little too high. Top Speed is up there. I can tell it's pulling some amps since I'm detecting some heat from the 125 amp Quark Monster Pro. Quite the Peppy Motor if you ask me. I just have to get the gearing right and the temps in check.