RC-Monster Forums - View Single Post

magman · 07.11.2008, 08:57 PM

It is very simple. You need the castle link. One of the castle link ends goes into the plug end of the bec ( the end that normally plugs into the receiver ) and the other goes into your computer. You should set the bec for 6v. Any higher and you risk damaging your servos.

	(#2)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	07.11.2008, 08:57 PM It is very simple. You need the castle link. One of the castle link ends goes into the plug end of the bec ( the end that normally plugs into the receiver ) and the other goes into your computer. You should set the bec for 6v. Any higher and you risk damaging your servos. 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S