RC-Monster Forums - View Single Post - E-maxx 3906 Twin HV4400, 14cell 4200mAh

MaxxFreak · **Motor decisions.. -** 07.13.2008, 09:11 AM

I'm most likely will be getting the MGM 16024 from Mike. But I have been looking around the web for Lehner motors, Can anyone link me to a seller other than Finedesign (won't reply me email) and Lehner website is very helpful but in Euro

. I'm looking to get the 1950/4 LK HiAmp. Neu's website not very helpful in deciding which is better for what voltage and current draw. Are Lehner 2 poles motor(high PRM)? Neu seems to be 4 poler(more torque). But running a emaxx 3906 trans with 1:8 UE diffs, I have to go higher rpm option.

Question about motor winding, looks like the more windings the lower rpm/volt, does this mean more torque? if that's correct, why can't we have a lot of windings and bolt the motor output shaft directly to the diff's input shaft?

Suicideneil, I using your Gmaxx as my inspiration. How long are you able to run on that 6S2P A123 setup?

	(#13)
MaxxFreak GorillaMaxx G3 Carbon Offline Posts: 18 Join Date: Jun 2008 Location: Perth, Western Australia	Motor decisions.. - 07.13.2008, 09:11 AM I'm most likely will be getting the MGM 16024 from Mike. But I have been looking around the web for Lehner motors, Can anyone link me to a seller other than Finedesign (won't reply me email) and Lehner website is very helpful but in Euro. I'm looking to get the 1950/4 LK HiAmp. Neu's website not very helpful in deciding which is better for what voltage and current draw. Are Lehner 2 poles motor(high PRM)? Neu seems to be 4 poler(more torque). But running a emaxx 3906 trans with 1:8 UE diffs, I have to go higher rpm option. Question about motor winding, looks like the more windings the lower rpm/volt, does this mean more torque? if that's correct, why can't we have a lot of windings and bolt the motor output shaft directly to the diff's input shaft? Suicideneil, I using your Gmaxx as my inspiration. How long are you able to run on that 6S2P A123 setup?