RC-Monster Forums - View Single Post - Need 2-25 tooth 32 pitch, 6mm bore pinion

J3110 · 10:17 AM

Woops, meant to say 22-25 tooth...I have yet to see a 2 tooth pinion...what'd that be? a quadralateral?

Learning a lesson the hard way, it seems.
Long story made short, I got one of these guys only to find that it's got a 6mm shaft after the fact(didn't see the shaft dia mentioned in the testemonials and presumed it'd be 5mm).

So, I will be needing to find some 6mm bore pinions...or at least one of them.

I've googled and checked around at the various RC stores that I know of online and can't seem to find what I need, so I am thinking i may need to have one custom made?

This'll be going in my E-maxx presuming I can get some pinions for it.

Already been here: http://www.sdp-si.com/ (found it on runryder heli forum when googling 6mm bore pinion)
Couldn't find what I needed.

I also read somewhere that a mod 0.8 would be roughly equal to a 32 pitch.
Without a crash course in gear geometry can I get a quick yes or no considering my particular application?

	(#1)
J3110 RC-Monster Carbon Fiber Offline Posts: 98 Join Date: Feb 2008 Location: San Rafael, CA	Need 2-25 tooth 32 pitch, 6mm bore pinion - 07.27.2008, 10:16 AM Woops, meant to say 22-25 tooth...I have yet to see a 2 tooth pinion...what'd that be? a quadralateral? Learning a lesson the hard way, it seems. Long story made short, I got one of these guys only to find that it's got a 6mm shaft after the fact(didn't see the shaft dia mentioned in the testemonials and presumed it'd be 5mm). So, I will be needing to find some 6mm bore pinions...or at least one of them. I've googled and checked around at the various RC stores that I know of online and can't seem to find what I need, so I am thinking i may need to have one custom made? This'll be going in my E-maxx presuming I can get some pinions for it. Already been here: http://www.sdp-si.com/ (found it on runryder heli forum when googling 6mm bore pinion) Couldn't find what I needed. I also read somewhere that a mod 0.8 would be roughly equal to a 32 pitch. Without a crash course in gear geometry can I get a quick yes or no considering my particular application? Last edited by J3110; 07.27.2008 at 10:17 AM.