RC-Monster Forums - View Single Post

crazyjr · 04:13 AM

I have an XL1200, and i mounted the motor to a motor plate (had a truggy one sitting) and used a belt type wrench. Mine was giving me problems like that, It turned out that the wires were crossing in the motor. I just moved them around and the motor freed up, never had the problem again. I know i'm taking a chance on the motor, but it hasn't given me a reason to replace it since.

same motor also seperatred the rotor, from the shaft. I reglued it back with JB weld, just be sure to remove all the glue from the shaft and as much from the inside of the magnet as possible. This is only if the magnet hasn't split

	(#7)
crazyjr RC-Monster Dual Brushless Offline Posts: 3,794 Join Date: May 2005 Location: georgia	08.09.2008, 04:10 AM I have an XL1200, and i mounted the motor to a motor plate (had a truggy one sitting) and used a belt type wrench. Mine was giving me problems like that, It turned out that the wires were crossing in the motor. I just moved them around and the motor freed up, never had the problem again. I know i'm taking a chance on the motor, but it hasn't given me a reason to replace it since. same motor also seperatred the rotor, from the shaft. I reglued it back with JB weld, just be sure to remove all the glue from the shaft and as much from the inside of the magnet as possible. This is only if the magnet hasn't split Work because i gotta, play because i wanna People here hate Nitro, I love it. I start it, run it about 50 ft from me and it dies, I go after it. Perfect exercise Last edited by crazyjr; 08.09.2008 at 04:13 AM.