[hoovhartid]

Originally Posted by tc3_racer_001

whats this about pulling the red wire to program?
to run a castle bec, you remove the red wire from the esc;


do you mean if you ran without the inbuilt bec he would have to replace it to program and then remove it again to run it?
yes, not a dumb question.
there is a simple solution tho. You buy one of these (servo extension wire) to run between the esc and the Rx;



cut the red wire on the servo extension.

when you need to reprogram, just unplug the esc from the extension, do whatcha gotta do, and put it back.

i too like to know everything - or as much as i physically can -

me too!

hope that helps...