RC-Monster Forums - View Single Post

Serum · 10.19.2005, 04:55 AM

Well, here's what i did;

I used scotch brite. And dead shortened the three wires from the motor with a tie wrap, placed the 5mm shaft in my drill. It comes off pretty easy.

Jasper, i use caustic soda.. It does the same, only in a blink of an eye.. In about 2 seconds the colour is gone.. It can't be done on a motor though..

@jasper;

Be aware, dabid is laying low in the bushes to jump anyone who makes mistakes.. ;)

	(#6)
Serum RC-Monster Admin Offline Posts: 10,480 Join Date: Feb 2005	10.19.2005, 04:55 AM Well, here's what i did; I used scotch brite. And dead shortened the three wires from the motor with a tie wrap, placed the 5mm shaft in my drill. It comes off pretty easy. Jasper, i use caustic soda.. It does the same, only in a blink of an eye.. In about 2 seconds the colour is gone.. It can't be done on a motor though.. @jasper; Be aware, dabid is laying low in the bushes to jump anyone who makes mistakes.. ;)