[J3110]

Saw a vid of a guy running some kinda MT with jumbo kongs on it(over at slap-ma-fro productions) and he could drive it upside-down because the tires were so huge. Something like that would be essential for the revocam, first of all and something I've already seen done here in the states.

I think you are on to something with the distraction bit as I think that is basically the best use of an easily detected RC ground pounder. In fact, that's what I thought of when I was checking out that thread about the guys in Iraq that have converted their Baja 5b into brushless and slapped dualies on the back.

Say you're in a firefight with some rascals in south-central Falluja...send out the armor plated BL5b and drive it to the opposite side of the enemy to take their attention off of you. Put something on it that looks like it could do some damage(flat black painted paper towel roll or something like that, maybe).
Of course, the FPV camera would still be used, but just so you could drive it around barriers etc and remain under cover.

One of the finest arial surveilance vehicles I saw being developed was actually a co-ax heli design with one rotor above and one below the vehicle and a tripod extended off the lower spindle. It was big, so would be impractical for indoor use, but it seemed exceptionally stable. My thought is that another co-ax design would beat out a standard rotor design any day due to the extensive research the Navy's already done into the benifits of co-ax rotors during their early anti-sub efforts using drones.

I have yet to see a reasonably stable platform for indoor use and would expect it to be largely run by autopilot with the pilot only telling it where to go and not actually doing the keep it from crashing part.