Hi,
Quote:
Originally Posted by Arct1k
Motor mount please for a Hyper ST and X1CR but with the Motor down the centre line over the rear drive shaft with custom top plate...
|
I posted jpgs of Autocad LT dwgs of the very thing u refer to for the X1CR about 1 year + ago (could b nearly 2 years) but I cannot find anyone to make them.
Basically, it involves moving the center diff forward, tuck the batteries in saddle pack configuration closer to the center & motor at the center above the batteries. A top deck is put in to compensate for the torque rods that will not be there. At the time, I was dreaming of running 8S 4000mah using a BK3095. Unfortunately, still dreaming...
Regards,
Joe Ling