RC-Monster Forums - View Single Post - Need response from a Castle tech for MMM question

joeling · 09.02.2008, 10:43 AM

Well, I use mine in a non racing situation although it's on a track. I had to do the mod since the thing was DOA & I live far far away from CC. I have received my second V2 form Monster Mike. This one is likely to go into my FLM savage. I will run it stock until the BEC dies then do the mod. However, I still hope that I don't have to do any mods.

For the fan, I chop off the original connector & attached another servo lead & plug it into the receiver to receive power from the UBEC. I think a fan or any extra cooling is more than welcome in my part of the world where ambient temperature is anywhere between 30 to 35 deg C during rc session. I think this applies to TruckBasher in Singapore ya ? I was there last week & will be there again end of the month.

Regards,
Joe Ling

	(#106)
joeling RC-Monster Carbon Fiber Offline Posts: 463 Join Date: Aug 2005 Location: Malaysia	09.02.2008, 10:43 AM Well, I use mine in a non racing situation although it's on a track. I had to do the mod since the thing was DOA & I live far far away from CC. I have received my second V2 form Monster Mike. This one is likely to go into my FLM savage. I will run it stock until the BEC dies then do the mod. However, I still hope that I don't have to do any mods. For the fan, I chop off the original connector & attached another servo lead & plug it into the receiver to receive power from the UBEC. I think a fan or any extra cooling is more than welcome in my part of the world where ambient temperature is anywhere between 30 to 35 deg C during rc session. I think this applies to TruckBasher in Singapore ya ? I was there last week & will be there again end of the month. Regards, Joe Ling Hyper 9e Medusa 4S, Savage 5S MMM 8XL, Jammin' 4S Neu MMM, X2 Ninja JX, X2 MMM 5S Neu, E REVO Medusa 6S