RC-Monster Forums - View Single Post

JThiessen · 10:43 PM

Yes, they were disconnected - I'll just snip off the ends and start from scratch. Does this mean that I should re-do the bullets (is there a compatibility issue with my solder and theirs that would cause a continuity issue?). BTW, speaking of soldering the bullets - I read about how people filled the cup with solder, then stuck the wire in. My bullets have 2 holes in them, so filling them was not really an option. However, I drilled my hole in the workbench a little deeper, so that the holes were covered and filled it that way.

	(#12)
JThiessen RC-Monster Brushless Offline Posts: 2,436 Join Date: Nov 2005 Location: Edmonds WA	09.04.2008, 10:40 PM Yes, they were disconnected - I'll just snip off the ends and start from scratch. Does this mean that I should re-do the bullets (is there a compatibility issue with my solder and theirs that would cause a continuity issue?). BTW, speaking of soldering the bullets - I read about how people filled the cup with solder, then stuck the wire in. My bullets have 2 holes in them, so filling them was not really an option. However, I drilled my hole in the workbench a little deeper, so that the holes were covered and filled it that way. Losi 8T 1.0, Savage Flux - XL style, LST XXL, Muggy, 3.3 E-Revo Conversion and sitting outside 425hp, 831 Tq Dodge Ram Turbo Diesel. It SMOKES Last edited by JThiessen; 09.04.2008 at 10:43 PM.