RC-Monster Forums - View Single Post

SpEEdyBL · 09.15.2008, 10:40 PM

What voltage cuttoff are you using? The mm will limit the current to the motor in order to keep the battery voltage above the cutoff, so the low voltage cuttoff a bit lower and do a speed pass. I once did a bench test with my MM and a weak 3s pack and when the cuttoff was set to 9.3 volts, it wouldn't let the pack go below 9.6 volts under a load.

	(#18)
SpEEdyBL "Out of spec" enthusiast Offline Posts: 820 Join Date: May 2005	09.15.2008, 10:40 PM What voltage cuttoff are you using? The mm will limit the current to the motor in order to keep the battery voltage above the cutoff, so the low voltage cuttoff a bit lower and do a speed pass. I once did a bench test with my MM and a weak 3s pack and when the cuttoff was set to 9.3 volts, it wouldn't let the pack go below 9.6 volts under a load. Check out my custom converted 8ight: Sub 7lb, lowest CG of any 1/8 buggy http://www.rc-monster.com/forum/show...894#post367894 Area 52 Ranch Raceway T.R.C.R.