RC-Monster Forums - View Single Post - Home-made UBEC

MetalMan · 10.31.2005, 09:36 AM

I did yesterday morning :). I got pretty bad glitching when the car was about 30ft. away, but I am not sure yet what caused it. I also had bad throttle movement, which was either caused by the glitching or LVC kicking in with 4s Lipo. I did have the regulator right next to the RX, so that is the worst possible case for glitching.
This setup was terrible, though. The EVX and batteries weren't actually mounted, they were only sitting on the car. The next time I do this, I will do it right with everything mounted up and with the batteries charged to eliminate LVC problems.

	(#39)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	10.31.2005, 09:36 AM I did yesterday morning :). I got pretty bad glitching when the car was about 30ft. away, but I am not sure yet what caused it. I also had bad throttle movement, which was either caused by the glitching or LVC kicking in with 4s Lipo. I did have the regulator right next to the RX, so that is the worst possible case for glitching. This setup was terrible, though. The EVX and batteries weren't actually mounted, they were only sitting on the car. The next time I do this, I will do it right with everything mounted up and with the batteries charged to eliminate LVC problems. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz