RC-Monster Forums - View Single Post

killjoyken · 09.22.2008, 08:58 PM

Finally put my Savage back together last week with a few changes. This one is built for top speed/drag racing and I'm building a 2nd FLM Savage for bashing. This one's got HPI Phaltlines, HPI big bores, and a Tekno Neu 1515/1.5d powered by a MMM V2 w/CCBEC. I ran it on 4s to tune the suspension and it was doing pretty well.....until I lost control at about 50+ mph and slid sideways into a curb. Amazingly I only put a small crack on the inside of the rear wheel and bent the crap out of a rear CVD.

Pics:

Monster Max mount for quick fan replacement as well as keeping the case from popping apart. It also doubles as a flame guard for my lipos!

	(#42)
killjoyken RC-Monkey Poo Flinger Offline Posts: 122 Join Date: Feb 2008 Location: San Jose, CA	09.22.2008, 08:58 PM Finally put my Savage back together last week with a few changes. This one is built for top speed/drag racing and I'm building a 2nd FLM Savage for bashing. This one's got HPI Phaltlines, HPI big bores, and a Tekno Neu 1515/1.5d powered by a MMM V2 w/CCBEC. I ran it on 4s to tune the suspension and it was doing pretty well.....until I lost control at about 50+ mph and slid sideways into a curb. Amazingly I only put a small crack on the inside of the rear wheel and bent the crap out of a rear CVD. Pics: Monster Max mount for quick fan replacement as well as keeping the case from popping apart. It also doubles as a flame guard for my lipos!