Quote:
Originally Posted by Happywing
My MMM V2 has a bunch of mods, but I missed this one until a friend of mine pointed it out. It's been running good for a while, but I now see that two of the motor connectors are touching the heatsink. So far:
1. Case bottom mod
2. Case top mod
3. Remove fan
4. Disable BEC
5. Run Rx Lipo w/regulator
6. Change switch to MM switch (so it doesn't turn off mid-race)
7. Rx cable opening made bigger
8. Rx cable shrink wrapped
9. Connector/heatsink contact mod coming
High maintenance little controller!
|
Let me know how your connector/heat sink contact mod goes. I almost got Dremel happy, but I don't want to mess things up.