Quote:
Originally Posted by rootar
Im getting power through the cc/bec to my reciver and servo and fan so this is not the cause but all of a sudden it quit on me the other day and would not arm and will not give me ANY lights or tones, when i plug it into the castleink software it still reads and does what its supposed to but no lights,
any help.
i under stand that this isnt under castle warranty but id like to know if its fixable becasue its been working perfect for 6months on 5s and never got over 135 the day i was running.
|
Same happened to my esc but i was tunnin 3s lipo and it still worked but had no tone or lights so i contacted CC they said to send it in and they fixed the problem. I think they said they changed the leds and replaced the switch because i cut it off. But this time when i got it back I took it out of the platic case and carefully cut the switch from the board, and soldered the two points. Now it turns on when i connect the battery. (ill try to find the sheet of repair to see what they did to the esc exactly)