RC-Monster Forums - View Single Post

BrianG · 10.03.2008, 04:18 PM

I wasn't running a Tekno tray in my Revo, but I too noticed bending on that support arm. I was running 14xGP3300 cells in brick form and that is quite a bit heavier than a fuel tank, as Shark pointed out. I did something similar to what he did, but added an extra L bracket brace to support the tray instead. One part of the L was the tray support, the other side of the L was attached to the inside of the chassis with bolts.

	(#6)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	10.03.2008, 04:18 PM I wasn't running a Tekno tray in my Revo, but I too noticed bending on that support arm. I was running 14xGP3300 cells in brick form and that is quite a bit heavier than a fuel tank, as Shark pointed out. I did something similar to what he did, but added an extra L bracket brace to support the tray instead. One part of the L was the tray support, the other side of the L was attached to the inside of the chassis with bolts.