RC-Monster Forums - View Single Post - E-Revo to E-Slayer conversion Project

MetalMan · 10.04.2008, 05:06 AM

I did have to work the closing shift, and I know it's not night anymore, but here are the pics as promised:

And a sample of one of the standoffs I made, which is a 4x20mm set screw epoxied into a custom tapped aluminum tube:

This is the second set of parts, the first set of parts is equally as finished

. Now all that's left is the bottom/lower skidplate (will be made from 1/16" thick delrin and will span the entire width and a good portion of the length of the chassis).

	(#10)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	10.04.2008, 05:06 AM I did have to work the closing shift, and I know it's not night anymore, but here are the pics as promised: And a sample of one of the standoffs I made, which is a 4x20mm set screw epoxied into a custom tapped aluminum tube: This is the second set of parts, the first set of parts is equally as finished . Now all that's left is the bottom/lower skidplate (will be made from 1/16" thick delrin and will span the entire width and a good portion of the length of the chassis). SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz