RC-Monster Forums - View Single Post

Arct1k · 04:51 PM

They put a non conductive laquer on the bullets and I'm not sure if the HS annodising is conductive but yes there is concern that this can cause a shorting of the phases and hence cogging / failure of the esc.

It may work day1 but the laquer may wear off and create a short...

There was rumour that in V3 the battery side bullets were being removed to create a bit more room for the HS

	(#2)
Arct1k RC-Monster Mod Offline Posts: 6,597 Join Date: Apr 2007 Location: NJ	10.06.2008, 04:50 PM They put a non conductive laquer on the bullets and I'm not sure if the HS annodising is conductive but yes there is concern that this can cause a shorting of the phases and hence cogging / failure of the esc. It may work day1 but the laquer may wear off and create a short... There was rumour that in V3 the battery side bullets were being removed to create a bit more room for the HS Last edited by Arct1k; 10.06.2008 at 04:51 PM.