RC-Monster Forums - View Single Post

BrianG · 10.06.2008, 08:56 PM

Well, if it arms, it means power is getting to the motor. Try what Arct1c said, and if still not working;

1: Check radio settings and ensure EPA for both forwards and reverse is set to 100% and trim is centered. Recalibrate radio to ESC.

If that doesn't work;

2: The instructions say you are supposed to recalibrate your radio to the ESC again after programming. I never had to do this, but something to try.

If that doesn't work;

3: You said it ran fine before you programmed it, so maybe try resetting everything to default (maybe even reflash the firmware), recalibrate to your radio, and try again.

If that doesn't work, wait for more responses or call Castle....

	(#3)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	10.06.2008, 08:56 PM Well, if it arms, it means power is getting to the motor. Try what Arct1c said, and if still not working; 1: Check radio settings and ensure EPA for both forwards and reverse is set to 100% and trim is centered. Recalibrate radio to ESC. If that doesn't work; 2: The instructions say you are supposed to recalibrate your radio to the ESC again after programming. I never had to do this, but something to try. If that doesn't work; 3: You said it ran fine before you programmed it, so maybe try resetting everything to default (maybe even reflash the firmware), recalibrate to your radio, and try again. If that doesn't work, wait for more responses or call Castle....