RC-Monster Forums - View Single Post

sjcrss · 10.08.2008, 10:22 PM

linc, one suggestion you could use to lower the diff cup, is replace the 6X12 bearing on the cup side with a 8X12 bearing, then the end of the diff cup will fit nicely into the bearing, & you will gain a few MM doing this....

	(#8)
sjcrss Hyper 7 Erevo Center Diff Offline Posts: 1,195 Join Date: Dec 2005 Location: CNY (Syracuse/Binghampton area)	10.08.2008, 10:22 PM linc, one suggestion you could use to lower the diff cup, is replace the 6X12 bearing on the cup side with a 8X12 bearing, then the end of the diff cup will fit nicely into the bearing, & you will gain a few MM doing this.... Bl E-REVO Quark 125b Castle Creations-Neu 2200kv motor ((2s2p)(4s)7800mah 7.4v Lipo Pack E-Revo 1/8 scale Hyper 7 CD http://www.rc-monster.com/forum/show...1&goto=newpost